Universal Speed Sensor Interface

$295.00
SKU:
287-SS-10
Shipping:
Calculated at Checkout
Share Product:
Write a Review

TAPCO restricts the sale of this item to Wisconsin customers only.

Universal Speed Sensor Interface, Model # SS-10. For use with NS50 & 60 Models DMI's, and 4085 Installation Kit.

The SS-10 is a speed sensor that is intended for use along with the NiteStar DMI (50 or 60). It is mounted on either the firewall or under the dashboard of the vehicle. The SS-10 conditions and transfers the speed signal to the NiteStar for measurement and display. The signals are automatically converted, and the sensitive design of the SS-10 allows it to operate at low speeds.

  • Automatically converts signals
  • Variable sensitivity allows counting at low speeds
  • Permits a reduction in sensitivity for noisy environments
  • Virtually transparent to vehicle electronics, reducing error messages
  • Compatible with most vehicles
  • Mounts to firewall, or under dashboard
  • Includes self-diagnostic features to verify cable connection to DMI and operation of SS-10 electronics
  • Ruggedized enclosure withstands temperatures up to 240°F
  • Simplifies the installation of the NiteStar, eliminating errors and guesswork

Additional Product Specifications:

Feature Description
Calibration Two momentary switches available to select one of ten sensitivity settings and nine divisor settings. Settings are displayed on seven segment LEDs; switches are pressed to increment and decrement the setting(s)
Circuitry Intelligent design; utilizing a micro-processor
Divisor Settings 1:1; 1:2. 1:3; 1:4; 1:6; 1:8; 1:16; 1:32; 1:64
Maximum Sensitivity 5 mv RMS at 1 Hz square wave
Power Supply 10 to 40 VDC; negative ground 15.5 mA (nominal) at 12 VDC
Sensor Tap Test Verifies power supply and DMI cables are installed correctly (DMI should read 25 mph; ± 2 mph with a calibration factor of 1000; test executes for 10 seconds.)
Sensor Test Verifies sensor electronics are operating properly (DMI should read 25mph; ± 2 mph with a calibration factor of 1000; test executes for 10 seconds.)
Temperature Rating -40°F to 257°F (-40°C to 125°C)
Weight 0.31 lb

SKU Calibration Circuitry Divisor Settings Maximum Sensitivity Power Supply Sensor Tap Test Sensor Test Temperature Rating Weight
287-SS-10 Two momentary switches available to select one of ten sensitivity settings and nine divisor settings. Settings are displayed on seven segment LEDs; switches are pressed to increment and decrement the setting(s) Intelligent design; utilizing a micro-processor 1:1; 1:2. 1:3; 1:4; 1:6; 1:8; 1:16; 1:32; 1:64 5 mv RMS at 1 Hz square wave 10 to 40 VDC; negative ground 15.5 mA (nominal) at 12 VDC Verifies power supply and DMI cables are installed correctly (DMI should read 25 mph; ± 2 mph with a calibration factor of 1000; test executes for 10 seconds.) Verifies sensor electronics are operating properly (DMI should read 25mph; ± 2 mph with a calibration factor of 1000; test executes for 10 seconds.) -40°F to 257°F (-40°C to 125°C) 0.31 lb

Customers Also Viewed

Reliable Shipping
& Order Tracking

Learn More

Secure Checkout form
Credit Cards to TAPCO Credit

Learn More

Use Federal, State, & National
Cooperative Contracts

Learn More

Need help? we're available
to assist your needs

Contact Us