Universal Speed Sensor Interface

TAPCO SKU: 287-SS-10


Click image to enlarge

Price:

$295.00

Buy Item Online

$295.00

(Shipping shown at checkout)

Need help deciding?

TAPCO restricts the sale of this item to Wisconsin customers only.

Universal Speed Sensor Interface, Model # SS-10. For use with NS50 & 60 Models DMI's, and 4085 Installation Kit.

The SS-10 is a speed sensor that is intended for use along with the NiteStar DMI (50 or 60). It is mounted on either the firewall or under the dashboard of the vehicle. The SS-10 conditions and transfers the speed signal to the NiteStar for measurement and display. The signals are automatically converted, and the sensitive design of the SS-10 allows it to operate at low speeds.

  • Automatically converts signals
  • Variable sensitivity allows counting at low speeds
  • Permits a reduction in sensitivity for noisy environments
  • Virtually transparent to vehicle electronics, reducing error messages
  • Compatible with most vehicles
  • Mounts to firewall, or under dashboard
  • Includes self-diagnostic features to verify cable connection to DMI and operation of SS-10 electronics
  • Ruggedized enclosure withstands temperatures up to 240°F
  • Simplifies the installation of the NiteStar, eliminating errors and guesswork

Includes:
Velcro, DMI Electronic Interface

Specifications for Selected SKU 287-SS-10
Power Supply 10 to 40 VDC, negative ground 15.5 mA (nominal) at 12 VDC
Circuitry Intelligent design, utilizing a micro-processor
Calibration Two momentary switches available to select one of ten sensitivity settings and nine divisor settings. Settings are displayed on seven segment LEDs, switches are pressed to increment and decrement the setting(s)
Maximum Sensitivity 5 mv RMS at 1 Hz square wave
Divisor Settings 1:1, 1:2. 1:3, 1:4, 1:6, 1:8, 1:16, 1:32, 1:64
Sensor Tap Test Verifies power supply and DMI cables are installed correctly (DMI should read 25 mph, ± 2 mph with a calibration factor of 1000, test executes for 10 seconds.)
Sensor Test Verifies sensor electronics are operating properly (DMI should read 25mph, ± 2 mph with a calibration factor of 1000, test executes for 10 seconds.)
Length 2 3/5 in
Width 4 1/10 in
Height 1 4/5 in
Weight 0.31 lb
Temperature Rating -40°F to 257°F (-40°C to 125°C)

DISCLAIMER: Specifications are subject to change without notice. For additional specifications and details, please contact us!