TAPCO restricts the sale of this item to Wisconsin customers only.
The LED housing is one-piece injection-molded with hinge lugs, screw slots and openings at each end. The swing-down door is a single-piece injection-molded carbonate with two hinge lugs molded on the bottom of the door and two latch points on the bottom. The door is attached to the bottom of the housing using two cotterless locking pins. Two eye bolts and wing nuts on the top allow the door to be opened and closed without special tools.
- Meets or exceeds ITE specifications
- Design provides minimum weight but maximum rigidity and strength
- The housing is designed to work with a gasket supplied by the LED manufacturer
- Mounting is completely compatible with all standard signal hardware
- The housing is designed to accommodate 16-inch LEDs
- Heavy duty .156" thick material
The openings will accommodate standard 1.5" pipe brackets. The bottom opening of the housing has an integrally-cast locking boss. The radial angular grooves of the locking boss provide five-degree incremental positioning of the signal to eliminate rotation or misalignment. The housing is available with a knock-out plug at the top and bottom. This plug eliminates the need for additional hardware to close these openings when using a clam-shell or post-top mounting bracket.
The egg crate visor option is designed to eliminate sun phantom and minimize damage to the LED. The egg crate visor is inserted through the back side of the door and overlaps by 1/2". It is sealed when the door is closed, which prevents light from escaping between the visor and the door. The egg crate visor is available only in black. A tunnel visor is also available to be included either with or without the egg crate visor.
One-piece polycarbonate unit with serrations in five-degree increments on the top and bottom. The housing is equipped with stainless steel cotterless hinge pins and locking wing nut assemblies. Each housing has provisions for mounting two four-position terminal blocks, and one is included.
Same as standard housing, but with five mounting holes on one side to accommodate a clam-shell mounting bracket. Hinge pins and eye-bolts may easily be removed without tools to reverse door, allowing clam-shell mounting on either side without additional holes or plugs.
Dimensions / Weight
16 3/4"H x 18 3/4"W x 7"D (425 mm x 476 mm x 178 mm), 8 lbs (3.64 kg)
Dimensions / Weight with Tunnel Visor
16 3/4"H x 18 3/4"W x 13 3/4"D (425 mm x 476 mm x 349 mm), 10 lbs (4.54 kg)
Dimensions / Weight with Eggcrate Visor
16 3/4"H x 18 3/4"W x 13 3/4"D (425 mm x 476 mm x 191 mm), 10 lbs (4.54 kg)